In addition to the dyeing method for the formation of colorful webbing lanyards, there is another method, that is, jacquard, which is formed by changing the structure of the fabric to form patterns, and the effect of the formed patterns is lasting , we can also use colored yarns for jacquard weaving, which will form a variety of color changes according to the color changes and structural changes of the yarns. Since the jacquard lanyard is produced by a loom, the jacquard webbing may cause some problems on the surface of the fabric due to various conditions during production.
In less serious cases, the webbing manufacturer will usually remedy it by darning. As long as the damage is not very serious, it does not matter if it appears in the color of the webbing. Generally, the webbing manufacturer analyzes the pattern before darning. Find the same pattern as the hole pattern on the webbing and tie it with a small darning loop as the darning standard and pattern (if there is no darning loop, you can also do not tie it).
The method and steps of the jacquard hanging belt for darning are mainly divided into two steps:
1. Threading: Tie the damaged part to the right side of the jacquard webbing. When threading, the left and right are three lines away from the hole. The two colors are threaded in stages, and the upper thread is placed on the knitted small coils. Generally, live threads are left. (That is, the remaining silk should be appropriately longer, and there will be leftovers after weaving, and the remaining yarns should be locked on the reverse side of the fabric). For black silk, a large needle should be placed on the left side of the fabric, and another large needle should be placed on the left side of the fabric when white silk is applied. At the end of the yarn, there must be two yarns, one black and one white.
2. Collusion: The ground is the same as that of the plain socks. To tick out the pattern pattern, it is necessary to master the cycle law of the color of each vertical line according to the cycle law of the color of this row (that is, complete organization). When it is required to collude, each tick line must be carefully observed and counted on the pattern of the darning circle. The upper and lower patterns must be colluded correctly, and the relationship between the left and right patterns can not be wrong. The tightness of the coil is well controlled, and the color is selected properly, the effect after weaving will be the same as the original tissue without any flaws.
The jacquard hanging belt is darned, which can greatly reduce the loss caused by the failure of the loom, which is a process.
The above is a summary of the introduction of the ways to remedy the jacquard lanyard error. I hope it can help you. If you want to know more about the webbing, then click on the webbing information!